Toro Outcross 9060 Service Manual page 232

Status Display Controller (T2: TDM) (continued)
Electrical System: Electrical Component Testing
A 20 pin platform wire harness connector is attached to the controller. The
connection terminal function for the controller and the wire harness connector
pins are shown above.
Because of the solid state circuitry built into the controller, there is no method to
test the controller directly. A controller may be damaged if an attempt is made to
test it with an electrical test device (e.g. digital multimeter or test light).
Note: The InfoCenter Display, TECs, and the TDM used on the Outcross 9060
machine are matched for correct machine operation. If any of these components
are replaced for any reason, system software needs to be reloaded (contact an
Authorized Toro Distributor for assistance).
Page 6–24 Outcross 9060
18234SL Rev B