Toro 300 Series Setup Instructions

Classic garden tractor

Hide thumbs Also See for 300 Series:

Download this manual

Loose Parts

Note:

Use the chart below to identify parts for assembly.

DESCRIPTION

Hitch Pin

Hairpin Cotter – 1-7/8"

Flat Washer – 1/2 x 1"

Bolt – 1/4–20 x 3/4"

Hex Nut – 1/4–20

Hairpin Cotter – 1-7/8"

Flat Washer – 1/2 x 1"

Operator's Manual

Set Up Instructions

Riding Mower Safety Video

Printed in USA

CLASSIC GARDEN TRACTOR

300 SERIES

S/N 9900001 & Up

QTY.

Installing the hitch pin

Attaching the battery cables

Attaching accessory to lift bar

Read before operating tractor

Read before setting up tractor

View before operating tractor

The Toro Company – 1998

FORM NO. 3322–108

SET UP

INSTRUCTIONS

USE

Page 1 Attaching accessory to lift bar Flat Washer – 1/2 x 1” Operator’s Manual Read before operating tractor Set Up Instructions Read before setting up tractor Riding Mower Safety Video View before operating tractor The Toro Company – 1998 All Rights Reserved Printed in USA...
Page 2 Set-Up Instructions Checking the Tire Pressure Remove the filler caps from the battery. Slowly pour electrolyte into each cell until the electrolyte level is up to the lower part of the Check the front and rear tire pressure. The correct tube (Fig.
Page 3 Set-Up Instructions When the battery is fully charged, unplug the Installing the Drawbar Hitch charger from the electrical outlet, then disconnect the charger leads from the battery posts (Fig. 2). Insert the drawbar hitch pin into the drawbar hitch and secure it with a 1/2 x 1”...
Page 4 Set-Up Instructions Checking the Wiring and As applicable, check and test the operation of the following: Fasteners Engine, choke and throttle controls Inspect the tractor for any loose electrical Gauges connections and secure as required. Check the wire routing to make sure no moving parts Headlights (and taillights 314 only) interfere with the wires to cause a short.

9900001