Toro Outcross 9060 Service Manual page 165

Tandem Piston (Traction) Pump (P1) and (P2) Service (continued)
1. Housing (front)
2. Center section assembly
3. Housing (rear)
4. Shaft (front)
5. Swashplate bearing kit (2 each)
6. Swashplate (2 each)
7. Piston assembly (2 each)
8. Slipper retainer (2 each)
9. Slipper retainer guide (2 each)
10. Slipper hold down pin (6 each)
11. Cylinder block assembly (2 each)
12. Dowel pin (4 each)
13. Slider block (2 each)
14. Servo piston assembly (2 each)
15. O-ring (4 each)
16. Piston ring (4 each)
17. Plug with O-ring (2 each)
18. Plug with O-ring (4 each)
19. O-ring (4 each)
20. Servo Cylinder (4 each)
21. Locking plate (2 each)
Outcross 9060
18234SL Rev B
Figure 42 (continued)
22. Cap screw (4 each)
23. Orifice (4 each)
24. Dowel pin (4 each)
25. EDC feedback link (2 each)
26. Gasket (2 each)
27. EDC housing (2 each)
28. Screw (12 each)
29. Servo control solenoid coil (4 each) 50.
30. Coil nut (4 each)
31. O-ring (8 each)
32. Servo control solenoid valve (4
each)
33. O-ring (4 each)
34. Nut (2 each)
35. Plug with O-ring (2 each)
36. Screw (12 each)
37. Roller bearing assembly (2 each)
38. Retaining ring
39. Lip seal
40. O-ring
41. Shaft seal
42. Retaining ring
If a tandem piston (traction) pump failure occurred, refer to
Circuit (Closed-Loop) Component Failure (page 5–6)
regarding the importance of removing contamination from the
traction circuit.
For tandem piston (traction) pump service information, see the
Closed Circuit Axial Piston Pumps Service Manual
Circuit Axial Piston Pumps Repair
For servo control solenoid coil service information, refer to
(Piston) Pump Control Solenoid Coils (page
Note: The forward and reverse solenoid valves and coils for both the front and
rear pump are identical.
43.
44.
45.
46.
47.
48.
49.
51.
52.
53.
54.
55.
56.
57.
58.
59.
60.
61.
62.
63.
IMPORTANT
Instructions.
6–75).
Page 5–69
Bearing (2 each)
Coupling
Valve plate CW
Plug with O-ring (6 each)
Lifting lug
Screw
O-ring
Charge pressure relief valve
Nut
Spring (4 each)
SCR valve (4 each)
O-ring (4 each)
Backup ring (4 each)
O-ring (4 each)
O-ring (4 each)
SCR valve plug (4 each)
Gasket (2 each)
Valve plate CCW
Pin (2 each)
Shaft (rear)
Screw (6 each)
Traction
for information
Danfoss H1
and the Danfoss H1 Closed
Tandem Traction
Hydraulic System: Service and Repairs