Removing the Battery
Installing the Battery
Outcross 9060
18234SL Rev B
g254790
1.
Negative (-) battery cable
2.
Positive (+) battery cable
3.
Battery
4.
Battery retainer
Be careful when removing the battery cables and ensure that you do
not damage the terminal posts or cable connectors.
1. Ensure that the key switch and all accessories are in the O
2. Remove the knobs, washers and side cover from the left side of the machine.
3. Disconnect the negative (-) cable from the battery terminal, then disconnect
the positive (+) cable from the battery terminal.
4.
Remove the two (2) wing nuts and the battery hold down rod.
5.
Make sure that the battery filler caps are secure and remove the battery
from the battery compartment.
To prevent possible electrical problems, install only a fully charged
battery.
Figure 116
5.
Side cover
6.
Washer (2 each)
7.
Knob (2 each)
IMPORTANT
IMPORTANT
Page 6–81
position.
FF
Electrical System: Service and Repairs