Toro Outcross 9060 Service Manual page 101

Towing the Traction Unit (continued)
Outcross 9060
18234SL Rev B
g233998
1. Bypass valve assembly
2. 6 mm hex wrench
3. Plug
Note: To prevent hydraulic fluid leakage, do not loosen the bypass valve
assemblies.
2. Set the valves to the bypass position by inserting a 6 mm hex wrench through
the valve plug and turning the plunger all the way in clockwise. Repeat this
step for each bypass valve assembly (4 total).
3. To release the brake, lift and hold the manual valve while pumping the hand
pump.
4. Pump the hand pump until resistance is felt. When enough pressure has
been created, the manual valve will remain in the raised position and the
brake will be released.
5. After towing and before starting the engine, insert a 6 mm hex wrench
through the valve plug and turn the plunger all the way out counterclockwise.
Repeat this step for each bypass valve assembly (4 total).
6. Push the manual valve down to engage the parking brake.
7. Secure the 6 mm hex wrench provided and install the access panel.
Figure 18
4. Plunger (normal operating position)
5. Plunger (bypass position for towing)
Page 5–5 Hydraulic System: General Information