Toro Outcross 9060 Service Manual page 190

Removing the Rear Steering Cylinder (continued)
Installing the Rear Steering Cylinder
Hydraulic System: Service and Repairs
5. Disconnect the tie rods from the rear steering cylinder.
6. Clean the fitting and hydraulic line connections before disconnecting the
hydraulic lines to prevent system contamination.
7. Disconnect the hydraulic hoses. Cap the fittings and plug the hoses to
prevent system contamination.
8. Remove the fasteners securing the cylinder to the cylinder supports and
remove the cylinder from the machine.
9. If hydraulic fittings will be removed, mark fitting orientation for proper
assembly. Discard fitting O-rings.
1. Lubricate new O-rings and place them onto the fittings. If previously
removed, install the fittings into the cylinder ports using alignment marks
made during removal; refer to
Thread O-Ring Fittings) (page
2. Install the steering cylinder to the machine and secure with 4 cap screws
and flange nuts.
3. Remove the caps and plugs from the fittings and hoses and connect the
hydraulic lines to the cylinder; refer to
(O-Ring Face Seal) (page
4. Install the tie rods to the rear steering cylinder; refer to
Rods (page 7–5).
5. Lower the machine to the ground.
6. Operate the steering cylinder. Check for hydraulic leaks and correct if
necessary.
7. Install the rear PTO gear box; refer to
(page 7–22).
8. Install the rear speed sensor and connect the wire harness to the sensor.
9. Install the bed; refer to
10. Check the hydraulic fluid level and adjust if necessary before returning the
machine to service.
Installing the Hydraulic Fittings (SAE Straight
5–10).
Installing Hydraulic Hoses and Tubes
5–8).
Installing the Rear PTO Gear Box
Standard Bed (page
Page 5–94
Installing the Tie
8–21).
Outcross 9060
18234SL Rev B