Toro Outcross 9060 Service Manual page 45

Machine Faults (continued)
Fault ID Fault Title
P057C Decelerator
Pedal Position
Sensor -
Analog Short
to Ground
P057D Decelerator
Pedal Position
Sensor -
Analog Open
Circuit
P05E0 Decelerator
Pedal Position
Sensor -
Analog to
Decelerator
Pedal Neutral
Switch
– Digital
Correlation
Fault
P0615 Start Output -
Open Circuit
P0616 Start Output –
Overcurrent
Outcross 9060
18234SL Rev B
Controller
Fault Description
Action
Short to ground Traction is
detected on decelerator disabled until
ignition key is
pedal position sensor –
analog cycled
Open circuit detected Traction is
on decelerator pedal disabled until
position sensor – analog ignition key is
cycled
The analog and Traction is
digital inputs for the disabled until
decelerator pedal do ignition key is
not match cycled
Open circuit detected
on engine start output
Overcurrent detected
on engine start output.
Indicates a short to
ground
Recommended Service Actions
1. Use the InfoCenter to verify sensor
operation (TRACTION INPUTS–BRAKE
PEDAL SIGNAL)
2. If no voltage reading is displayed:
A. Check the decelerator pedal position
sensor wiring and connector
B. Test the sensor wiring
3. Test the decelerator pedal position sensor
and replace if necessary
1. Use the InfoCenter to verify sensor
operation (TRACTION INPUTS–BRAKE
PEDAL SIGNAL)
2. If no voltage reading is displayed:
A. Check the decelerator pedal position
sensor wiring and connector
B. Test the sensor wiring
3. Test the decelerator pedal position sensor
and replace if necessary
1. Make sure the decelerator pedal moves
freely to its full rest (up) position
2. Use the InfoCenter to verify neutral switch
operation (TRACTION INPUTS–BRAKE
NEUTRAL ON)
3. Use the InfoCenter to verify position sensor
operation (TRACTION INPUTS–BRAKE
PEDAL SIGNAL)
4. If no voltage reading is displayed:
A. Check the decelerator pedal position
sensor wiring and connector
B. Test the position sensor wiring
5. Check the decelerator pedal neutral switch
wiring and connector
6. Test the neutral switch wiring
7. Test the decelerator pedal neutral switch
and replace if necessary
8. Test the decelerator pedal position sensor
and replace if necessary
1. Check the engine start output circuit wiring
and all of the output circuit connectors
2. Test the engine start output circuit wiring
between T1: TEC and Engine ECU
3. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
1. Check the engine start output circuit wiring
and all of the output circuit connectors
2. Test the engine start output circuit wiring
between T1: TEC and Engine ECU
3. Replace the T1: TEC (contact your
Authorized Toro Distributor for assistance)
Page 3–7 Troubleshooting: Attachment/Loader Problems