Fuse Identification, Location and Function (continued)
Outcross 9060
18234SL Rev B
•
Fuse F−D2 ( 15 Amp) supplies unswitched power to the cab control panel for
an optional radio, and to the International (EC) road light kit.
•
Fuse F−A3 (10 Amp) supplies power to the optional hour meter, optional bed
active switch, backup alarm, traction speed sensors, cruise control auto off
switch, and ECO mode switch bulb.
•
Fuse F−B3 (2 Amp) supplies power to the InfoCenter display.
•
Fuse F−C3 (10 Amp) supplies power to the headlights/worklights.
•
Fuse F−D3 (10 Amp) supplies power to the power point, USB charge port,
and optional selector control valve (SCV) kit.
•
Fuse F−A4 (2 Amp) supplies power to the T2: TDM outputs 1 thru 3.
•
Fuse F−B4 (10 Amp) supplies power to the North American (NA) road light kit.
•
Fuse F−C4 (10 Amp) supplies power to the horn.
•
Fuse F−D4 (10 Amp) supplies power to the optional beacon.
•
Fuse F−A5 (10 Amp) supplies power to the air-ride seat compressor.
•
Fuse F−B5 (20 Amp) supplies power to the optional trailer brake controller.
•
Fuse F−C5 (10 Amp) supplies switched power to expansion ports #1 and #2.
•
Fuse F−D5 (15 Amp) supplies switched power to the rear attachment
connector.
Accessory Fuse Block
• Fuse (10 Amp) supplies power to the loader selector control valve (SCV) kit.
g256627
1.
Cab fuse block
2.
Knob (2 each)
Cab Fuse Block
•
Fuse IF-1 is unused and available for optional equipment
•
Fuse IF-2 (40 Amp) supplies power to the mixing box blower and the
defroster blower.
•
Fuse IF-3 (20 Amp) supplies power to the windshield wipers.
•
Fuse IF-4 (25 Amp) supplies power to the condenser fans.
Figure 75
3.
Access panel
Page 6–15
Electrical System: Electrical Component Testing