Toro Outcross 9060 Service Manual page 310

Disassembling the Front PTO Gear Box
g244466
1. Cover
2. Shaft seal
3. Plate
4. Flange head screw (4 each)
5. Retaining ring
6. Bearing
7. Retaining ring (2 each)
8. Gear – 64T
9. Key (2 each)
10. Input shaft
11. Bearing
12. Wave washer
13. Wave washer
Traction and PTO Drive: Service and Repairs
14. Bearing
15. Retaining ring
16. Thrust washer (2 each)
17. Gear – 77T
18. Needle bearing
19. Clutch assembly
20. O-ring
21. Dowel pin (2 each)
22. Plug
23. Case
24. Eyebolt
25. Coupler
26. Retaining ring
1. Remove the retaining ring and hub from the output shaft.
2. Remove the socket head cap screws and use the tabs provided to pry the
cover from the gear box.
3. Retrieve the dowel pins from the cover or case, and retrieve the wave
washers from the clutch shaft and the output shaft assemblies.
4. Remove the input shaft assembly from the gear box case.
Figure 125
27.
28.
29.
30.
31.
32.
33.
34.
35.
36.
37.
38.
Page 7–16
Hub
Plate
Shaft seal
Plug
Plug (4 used)
Bearing (2 each)
retaining ring (2 each)
Output shaft
Gear – 84T
Wave washer
Cap screw (11 each)
Outcross 9060
18234SL Rev B