Toro Outcross 9060 Service Manual page 333

Removing the Operator's Platform (continued)
Installing the Operator's Platform
Outcross 9060
18234SL Rev B
The operator's platform assembly can rest on the right and left steps.
Support the front and rear of the platform assembly with blocks or
jack stands to prevent it from tipping.
21. Raise the operator platform clear of the machine, then lower the platform
assembly to the floor.
1. Using the 4 lift points provided, lower the operator platform over the machine
chassis. Place blocks between the operator platform mounts and the chassis,
then ensure all the required hoses and wire harnesses are safely routed to
the chassis.
2. Align the cab to the chassis and install the 4 cap screws, snubbing washers
and flange nuts. Install the plugs over the 2 front mounts.
3. For machines equipped with a front loader, fit the rubber boot over the loader
valve and install the jam nut and knob.
4. Install the rubber boot over the auxiliary load valve.
To prevent damage to the electrical wire harnesses, coolant hoses,
and refrigerant hoses, numerous cable ties and clamps are used to
secure these items to the machine. Replace all cable ties and clamps
that were removed from the machine during operator platform
removal.
5. Connect the refrigerant lines at the compressor if equipped.
6. Connect the heater hoses at the engine if equipped.
7. Connect the 3 hydraulic hoses to the bulkhead at the rear of the operator
platform.
8. Install the relay assembly and the main instrument panel.
9. Connect the 7–pin engine wire harness connector P18 to the main harness.
10. Connect the 3–pin engine wire harness connector P63 to the main harness.
11. Connect the operator platform wire harness to the frame wire harness at the
2 connectors (under the right side of the dash cover).
12. Connect the engine wire harness to the engine ECU.
13. Connect the hoses at the hydraulic manifold ST and LS/OR1 ports.
14. Connect the battery positive (+) and negative (-) cables to the terminal
bracket posts.
15. Install the access panel to the right side of the control console.
16. Install the front fenders.
17. Connect the battery; refer to
18. Install the front cowl.
19. Install the bed; refer to
bed Installation Instructions .
IMPORTANT
IMPORTANT
Installing the Battery (page
Standard Bed (page
Page 8–13
6–81).
8–21), or the optional cargo
Chassis: Service and Repairs