Axle Motors - Toro Outcross 9060 Service Manual

Axle Motors

g264149
1. Axle motor
2. Cap screw (2 each)
3. Gasket (rear axle only)
Removing the Axle Motors
Hydraulic System: Service and Repairs
(rear axle shown)
4. Hydraulic brake assembly (rear axle
only)
5. Drive coupler
6. Speed sensor
Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page 5–49)
removing hydraulic system components.
1. To prevent contact between the face of the speed sensor and the drive
coupling during axle motor removal, remove the speed sensor from the
motor mount.
2. To prevent contamination of the hydraulic system during motor removal,
thoroughly clean the exterior of the motor and fittings.
3. Label and disconnect the hydraulic hoses from the axle motor. To prevent
contamination of hydraulic the system, plug the disconnected hoses and
cap the fittings.
Note: The 2 cap screws that secure the rear axle motor to the motor mount
also secure the hydraulic brake assembly.
Figure 47
Page 5–76
7. Motor mount
General Precautions for
18234SL Rev B
prior to
Outcross 9060