Toro Outcross 9060 Service Manual page 88

Removing and Installing the Fuel Tank (continued)
Engine: Service and Repairs
To prevent damage to the fuel hoses, numerous cable ties and
clamps are used to secure the hoses to the machine components.
Record the location of all cable ties and clamps that are removed
from the machine so they can be properly replaced.
8. Label the fuel hoses for assembly purposes. Loosen the hose clamps and
disconnect the hoses from the fuel tank.
9. Cover or plug the fuel hoses or fitting openings to prevent contamination
from entering the fuel system.
10. Lower the tank and support bracket to the ground. Separate the tank and
bracket by removing the 3 clamps if necessary.
11. If the fuel level sender is removed, use a new gasket when installing the
fuel sender.
12. If the elbow fittings are removed from the fuel/water separator head, apply
thread sealant to the fittings when installing.
13. To install the fuel tank, follow this procedure in reverse order.
IMPORTANT
Page 4–16 Outcross 9060
18234SL Rev B