Toro Outcross 9060 Service Manual page 177

Installing the Hydraulic Brake
Outcross 9060
18234SL Rev B
1. Lubricate new O-rings and place them onto the fitting. If previously removed,
install the fitting into the brake port using alignment mark made during
removal; refer to Installing the Hydraulic Fittings (SAE Straight Thread
O-Ring Fittings) (page
2. Apply anti-seize lubricant to the splines of the drive coupler. Align the drive
coupler splines and slide the drive coupler all the way onto the axle input
shaft.
3. Apply anti-seize lubricant to the splines of the hydraulic brake assembly.
4. Align the hydraulic brake splines and slide the brake assembly shaft into
the drive coupler.
5. Install a new gasket between the hydraulic brake assembly and the rear
axle motor.
6. Install the rear axle motor; refer to
7. Check the hydraulic brake oil level and adjust if necessary; refer to the
traction unit Operator's Manual.
8. Test the hydraulic brake operation before returning the machine to service.
5–10).
Installing the Axle Motors (page
Page 5–81
5–77).
Hydraulic System: Service and Repairs