Toro Outcross 9060 Service Manual page 216

Status Display Controller (T2: TDM) (continued)
Electrical System: General Information
g259775
1. Engine hour meter
2. Fuel level
3. Active fault
4. Engine coolant temperature
5. Hydraulic fluid temperature
6. System voltage
The T2: TDM is also a 2002 series microcontroller that monitors the condition of
various machine switches and sensors (inputs) and communicates the status of
these inputs to the T1: TEC via the CAN. The status of inputs to the controller
can be monitored with the InfoCenter Display; refer to
Display for Troubleshooting (page
The primary controller (T1: TEC), the status display controller (T2: TDM),
the Yanmar Engine Control Unit (ECU), the InfoCenter Display, and the
optional InchMode controller (T3: TEC) used on the Outcross 9060 machine
communicate with each other on a Controller Area Network (CAN) bus system.
Note: The InfoCenter Display, TECs, and the TDM used on the Outcross 9060
machine are matched for correct machine operation. If any of these components
are replaced for any reason, system software needs to be reloaded (contact an
Authorized Toro Distributor for assistance).
Figure 70
Status Display Screens
7. Engine RPM
8. Hitch raise limit
9. Hitch maximum work height (PTO
disengage)
10. Hitch minimum work height (PTO
disengage)
11. Hitch lower limit
12. Current hitch position
3–23).
Page 6–8
Using the InfoCenter
Outcross 9060
18234SL Rev B