Toro Outcross 9060 Service Manual page 119

g236339
Outcross 9060
18234SL Rev B
Hitch Cylinder Circuit Diagram (lowering)
The 3-point hitch on the machine uses two (2) hydraulic cylinders to raise and
lower the hitch arms. The cylinders are controlled by the paddle located below
the left side of the steering wheel. A position sensor is connected to the hitch
arm pivot shaft, allowing the T1: TEC to monitor the position of the 3-point hitch.
Some attachments may be configured to control the 3-point hitch automatically.
The gear pump section furthest from the piston pump, gear pump section (P4),
supplies fluid to a variety of circuits including the hitch lift circuit. Hydraulic fluid
from gear pump (P4) enters the main manifold port P and flows through the
steering priority valve (EC1); refer to
explanation of the steering priority valve (EC1) operation. Fluid flow continues
through the flow regulator valve (EC2) where it dead heads at solenoid valve
Steering Circuit (page 5–18)
Page 5–23 Hydraulic System: Hydraulic Flow Diagrams
for a full