Toro Outcross 9060 Service Manual page 195

Installing the 3-Point Hitch Cylinder
Outcross 9060
18234SL Rev B
1. Lubricate new O-rings and place them onto the fittings. If previously removed,
install the fittings into the cylinder ports; refer to
Fittings (SAE Straight Thread O-Ring Fittings) (page
2. Apply general purpose grease to the lower cylinder clevis. Position the hitch
cylinder to the machine frame and install the lower pin.
3. Remove the caps and plugs from the fittings and hoses and connect the
hydraulic lines to the cylinder; refer to
(O-Ring Face Seal) (page
4. Install the upper pin securing the cylinder to the lift arm.
5. Install the standard arm assembly, lift link assembly, and stabilizer assembly.
6. Grease the lower cylinder pin fitting with Mobil high-temp XHP-222 or
equivalent.
7. Operate the 3-point hitch. Check for hydraulic leaks and correct if necessary.
8. Check the hydraulic fluid level and adjust if necessary before returning the
machine to service.
Installing Hydraulic Hoses and Tubes
5–8).
Page 5–99
Installing the Hydraulic
5–10).
Hydraulic System: Service and Repairs