Toro Outcross 9060 Service Manual page 316

Replacing Rear Gear Box Seals
Installing the Rear PTO Gear Box
Traction and PTO Drive: Service and Repairs
g245027
1. Retaining ring
2. Hub
3. Flange head screw (4
each)
4. Plate (2 each)
1. Remove the retaining ring and the hub from the gear box input shaft.
2. Remove the flange head screws, plate and retaining ring to access either
shaft seal.
3. Carefully remove and discard the shaft seal.
4. Clean the gear box housing bore and cover the shaft splines with tape to
protect the shaft seal during installation.
5. Install the shaft seal and remove the tape from the shaft splines.
6. Install the retaining ring and the plate. Tighten the flange head screws from
24.5 to 32.5 N∙m (18 to 24 ft-lb).
7. Apply a thin layer of anti-seize lubricant to the splines of the input shaft and
hub, then install the hub and retaining ring.
1. Support the rear PTO gear box from overhead.
2. Lift the gearbox into the machine and install the 6 cap screws securing the
rear of the gear box housing to the frame.
Figure 129
5. Retaining ring (2 each)
6. Shaft seal (2 each)
7. Plug
8. Barb elbow
Page 7–22
9. Eyebolt
10. Magnetic plug
Outcross 9060
18234SL Rev B