Toro Outcross 9060 Service Manual page 173

Removing the Axle Motors (continued)
Installing the Axle Motors
Outcross 9060
18234SL Rev B
4. Remove the 2 cap screws that secure the axle motor to the motor mount.
Separate the motor from the motor mount or hydraulic brake and remove
the motor from the machine.
5. If removing the rear axle motor, retrieve and discard the gasket between the
axle motor and the hydraulic brake assembly.
6. Remove and inspect the front drive coupler, or, remove and support the
hydraulic brake assembly then remove and inspect the rear drive coupler.
7. If fitting removal is necessary, mark the fitting orientation to allow for correct
assembly then remove the fittings from the pump and discard the O-rings.
1. Lubricate new O-rings and place them onto the fittings. If previously
removed, install the fittings into the motor ports using alignment marks made
during removal; refer to
O-Ring Fittings) (page
2. Apply anti-seize lubricant to the splines of the drive coupler. Align the drive
coupler splines and slide the drive coupler all the way onto the axle input
shaft.
3. If installing the rear axle motor:
A. Apply anti-seize lubricant to the splines of the hydraulic brake assembly.
B. Align the hydraulic brake splines and slide the brake assembly shaft
into the drive coupler.
C. Install a new gasket between the hydraulic brake assembly and the rear
axle motor.
4. Apply anti-seize lubricant to the splines of the axle motor shaft. Align the axle
motor splines and slide the axle motor into the drive coupler (front motor) or
hydraulic brake (rear motor).
5. Secure the axle motor using the 2 cap screws previously removed.
6. Remove caps and plugs from hydraulic fittings and hoses and install the
hydraulic hoses to the axle motor; refer to
Tubes (O-Ring Face Seal) (page
7. Test axle motor operation before returning the machine to service:
A. Check the hydraulic fluid level and adjust if necessary.
B. Operate the machine slowly at first.
C. Stop the engine then check for and correct any hydraulic leaks.
D. Check the hydraulic fluid level and adjust if necessary.
Installing the Hydraulic Fittings (SAE Straight Thread
5–10).
Installing Hydraulic Hoses and
5–8).
Page 5–77 Hydraulic System: Service and Repairs