Toro Outcross 9060 Service Manual page 58

Machine Faults (continued)
Fault ID Fault Title
B1027 Cruise Control
Speed
Increase/
Decrease
Switch is
Broken
B1107 Transmission
Lever Switch
Broken
B1117 Optional
InchMode
Raise/Lower
Switch Broken
B1127 Optional
InchMode
Forward/
Reverse
Switch Broken
B1137
Paddle Switch
Broken
B1154 Mode Selector
- Short to
Ground
B1155 Mode Selector
- Open Circuit
Troubleshooting: Attachment/Loader Problems
Controller
Fault Description
Action
Both CRUISE Cruise speed
CONTROL increase/
INPUTS–SPEED decrease is
INCREASE and disabled
CRUISE CONTROL
INPUTS–SPEED
DECREASE are active
at the same time
Both TRACTION Traction is
INPUTS–TRANMISSION disabled
FWD and TRACTION
INPUTS–TRANMISSION
REV are active at the
same time
Both INCH MODE InchMode 3-point
INPUTS–INCH MODE hitch control is
LOWER and INCH disabled
MODE INPUTS–INCH
MODE RAISE are active
at the same time
Both INCH MODE InchMode traction
INPUTS–INCH MODE control is disabled
FWD and INCH MODE
INPUTS–INCH MODE
REV are active at the
same time
3-point hitch
Both 3-POINT
INPUTS–3-POINT control is disabled
LOWER and 3-POINT
INPUTS–3-POINT
RAISE are active at the
same time
Short to ground Default to low
detected on mode mode operation
selector and disable PTO
Open circuit detected Default to low
on mode selector mode operation
and disable PTO
Recommended Service Actions
1. Check the cruise control speed
increase/decrease switch circuit wiring and
all the circuit connectors
2. Test the cruise control speed
increase/decrease switch
3. Test the cruise control speed
increase/decrease switch circuit wiring
1. Use the transmission lever and
the InfoCenter to determine which
transmission lever switch does not match
transmission lever movement (TRACTION
INPUTS–TRANMISSION FWD and
TRACTION INPUTS–TRANMISSION REV)
2. Check the circuit wiring and all the circuit
connectors for the unresponsive switch
3. Test the unresponsive switch
4. Test the unresponsive switch circuit wiring
1. Check the optional InchMode raise/lower
switch circuit wiring and all the circuit
connectors
2. Test the optional InchMode raise/lower
switch
3. Test the optional InchMode raise/lower
switch circuit wiring
1. Check the optional InchMode
forward/reverse switch circuit wiring
and all the circuit connectors
2. Test the optional InchMode forward/reverse
switch
3. Test the optional InchMode forward/reverse
switch circuit wiring
1. Use the paddle and the InfoCenter to
determine which paddle switch does
not match paddle movement (3-POINT
INPUTS–3-POINT LOWER and 3-POINT
INPUTS–3-POINT RAISE)
2. Check the circuit wiring and all the circuit
connectors for the unresponsive switch
3. Test the unresponsive switch
4. Test the unresponsive switch circuit wiring
1. Check the mode selector circuit wiring and
all circuit connectors
2. Test the mode selector circuit wiring
3. Test the mode selector if possible and
replace if necessary
1. Check the mode selector circuit wiring and
all circuit connectors
2. Test the mode selector circuit wiring
3. Test the mode selector if possible and
replace if necessary
Page 3–20 Outcross 9060
18234SL Rev B