Testing the Fuel Pump (continued)
Electrical System: Electrical Component Testing
g232341
1.
Engine fuel filter
4. Disconnect the fuel hose coming from the fuel pump at the engine fuel filter.
When testing the fuel pump output, do not turn the key switch to
the START position
5. Place the disconnected hose end into a 0.95 liter (1 quart) graduated cylinder
and set the key switch to the ON/RUN position for 30 seconds. The pump
should deliver approximately 350 ml (11.8 ounces) in 30 seconds. Replace
the fuel pump if necessary.
6. Connect fuel hoses and secure with hose clamps.
7. Prime the fuel system; refer to
Figure 100
2.
Fuel hose (from pump)
IMPORTANT
Priming the Fuel System (page
Page 6–60
4–15).
Outcross 9060
18234SL Rev B