Table of Contents
Advertisement
Task 3. Set up the sequence table
Steps
1 Set up the sequence table to:
•
Run duplicate injections of a blank.
•
Run duplicate injections of the
sulfa mix at three concentrations:
1, 5 and 10 ng/µL.
•
Use the method
SULFA MS SIM 1.M, that you
created in
Chapter
4, "Set Up and
Run a SIM Method".
Agilent 6100 Series Quadrupole LC/MS Systems Familiarization Guide
Detailed Instructions
a Click Sequence > Sequence Table.
b In the first line, type these values:
•
Sample Location = 1
•
Sample Name =
ng/ul sulfas
•
Method
Name=SULFA MS SIM 1
•
Inj/Loc=2
•
Sample Type=Sample
c Select Line 1.
d Click the Insert/Filldown Wizard
button.
e Complete the Insert/Filldown
Wizard as shown in the next figure.
Set Up and Run a Sequence
Task 3. Set up the sequence table
Comments
• In this step, you set up the parts of
the sequence table that are
common to all the samples.
• You will specify the sample names
later in this exercise.
• There are a number of ways to add
samples to the sequence table. This
exercise illustrates just one of the
ways — use of the Insert/Filldown
Wizard.
5
55
Advertisement
Table of Contents
