Steps
4 Do one of the following:
•
Open the data file,
SULFA_SCAN00001.D, which you
acquired in
Chapter
•
Open the data file mssulfas.d,
located in the MSDEMO folder.
Agilent 6100 Series Quadrupole LC/MS Systems Familiarization Guide
Detailed Instructions
a Select File > Load Signal.
b Navigate to the appropriate folder,
either:
2.
•
C:\CHEM32\1\DATA\SULFAS,
or
•
C:\CHEM32\1\DATA\MSDEMO.
c Select the data file.
d Set other parameters as shown
below and click OK.
Exercise 1. Display and manipulate chromatograms
Comments
• For other ways to load signals, see
• If you wish to complete
Qualitative Data Analysis
the Data Analysis chapter in the
Concepts Guide.
Chapter
"Set Up and Run a SIM Method",
then you need to process the data
file you generated in
Chapter
need the report from that data file
to set up your SIM groups.
3
4,
2. You
29