Task 4. Set Up The Sequence Output - Agilent Technologies 6100 Series Familiarization Manual

5 Set Up and Run a Sequence

Task 4. Set up the sequence output

Task 4. Set up the sequence output

Steps
1 Set up the sequence to print a short
sequence summary to the printer.
58
Detailed Instructions
a Click Sequence > Sequence
Parameters > Sequence Output.
b Mark the check box for Print
sequence summary report.
c Mark the check box for Report to
printer.
d Click the Setup button.
e Fill in the dialog box as shown
below.
f Click OK in the Sequence Summary
Parameters dialog box.
g Click OK in the Sequence
Parameters dialog box.
Agilent 6100 Series Quadrupole LC/MS Systems Familiarization Guide
Comments
• In addition to the sequence
summary report, you can print
individual sample reports, as
specified in your method. (You do
not print individual reports in this
exercise.)
• For details about sequence reports,
see the chapter on ChemStation
reports in Agilent ChemStation:
Understanding Your ChemStation.
• The setup shown in the dialog box
below prints the simplest summary
report.