Setting Up A Password - Intelligent Lighting Controls, Inc. LightLEEDer Operation Manual

Programming
Switch Between Custom and Default Names:
1. From the home screen, press
connect to the Network Controller Node 00 as shown in
Section 3.0)
2. Press until sPeCIAl FUnCTIOns appears
3. Press sPeCIAl FUnCTIOns
4. Press eDIT nAMes
5. Press to scroll down
6. Press shOW nAMes to toggle between custom and default
names for all categories
Set all Names to the Default:
1. From the home screen, press
connect to the Network Controller Node 00 as shown in
Section 3.0)
2. Press until sPeCIAl FUnCTIOns appears
3. Press sPeCIAl FUnCTIOns
4. Press eDIT nAMes
5. Press to scroll down to DeFAUlT nAMes
6. Press DeFAUlT nAMes to set the default names for all
categories

3.9.2 Setting up a Password

Passwords are suggested to protect the system programming from
inadvertent changes from personnel not trained properly. Two levels
of access are available with level 1 allowing full access, and level 2
allowing control and status only.
Note: The default setting is 000000 which allows access without entering
a password.
1. From the home screen, press
connect to the Network Controller Node 00 as shown in
Section 3.0)
2. Press until sPeCIAl FUnCTIOns appears
3. Press sPeCIAl FUnCTIOns
4. Press ChAnge PAssWORDs
5. Press COnTROl OnlY (level 2) or COnTROl/eDIT (level 1)
6. Press or to scroll to the space to edit
7. Press or to change to the desired letter,
number, or character.
8. Press or to scroll to the next space to edit
9. Continue until all characters have been edited
(Be sure to record the password)
10. Press sAVe to store the programming
ILC LightLEEDer Operation Manual
Version 1C 3/14/17
eDIT (Networked Panels
eDIT (Networked Panels
eDIT (Networked Panels
Switch Between Custom and Default Names
EDIT NAMES
CHANGE PASSWORDS
FIRMWARE REVISION
From the sPeCIAl FUnCTIOns screen,
press eDIT nAMes
EDIT TIMER NAMES
EDIT PRESET NAMES
DEFAULT NAMES
SHOW NAMES:CUSTOM
Press shOW nAMes to toggle
between custom and default
Set all Names to the Default
EDIT NAMES
CHANGE PASSWORDS
FIRMWARE REVISION
From the sPeCIAl FUnCTIOns screen,
press eDIT nAMes
EDIT TIMER NAMES
EDIT PRESET NAMES
DEFAULT NAMES
SHOW NAMES:CUSTOM
Press DeFAUlT nAMes
Setting up a Password
EDIT NAMES
CHANGE PASSWORDS
FIRMWARE REVISION
From the sPeCIAl FUnCTIOns screen,
press ChAnge PAssWORDs
CHANGE PASSWORDS
CONTROL ONLY
CONTROL/EDIT
Press COnTROl OnlY or COnTROl/eDIT
to select level
CLEAR PASSWORD
OOOOOO
^
SAVE
Press or then scroll
to the desired number