Programming
3.4 Clock Settings
Clock settings must be set in the controller if the panel executes time
schedules or turns on/off lights in reference to sunrise/sunset.
3.4.1 Set the Time and Date
1. From the home screen, press
connect to the Network Controller Node 00 as shown in
Section 3.0)
2. scroll
until ClOCK appears
3. Press
ClOCK
4. Press
TIMe/DATe, the programmed time and date will be
displayed
5. Press
TIMe to make changes to the time
6. From this screen press
buttons to make adjustments to either. Be sure that AM/PM
is indicated properly for the time of day.
7. When the time is correct, press
8. If the date requires adjustment press
9. select MOnTh, DATe, or YeAR and press
button then press
10. When the time is correct, press
11. Press "hOMe" to exit to the home screen
3.4.2 Set Daylight Saving Time
1. From the home screen, press
connect to the Network Controller Node 00 as shown in
Section 3.0)
2. scroll
until ClOCK appears
3. Press
ClOCK
4. Press
DAYlIghT sAVIng
5. Press
COnFIg DsT to toggle from enable to disable
6. Press
sTART DATe or enD DATe to adjust the date
7. Press "hOMe" to exit to the home screen
note: The default settings are start: 2nd week in March, end: 1st
week in november.
ILC LightLEEDer Operation Manual
Version 1C 3/14/17
eDIT (Networked Panels
hOUR or MInUTe and use the
seT
DATe
the corresponding
or
to adjust the values
seT
eDIT (Networked Panels
Set the Time and Date
ILC LIGHTLEEDER
EDIT
Press
eDIT, scroll down until ClOCK appears
RELAYS
INPUTS
TIMERS
CLOCK
Press
TIME/DATE
or
DAYLIGHT SAVINGS
ASTRO CLOCK
SUNRISE/SUNSET
Press
SET
TIME/DATE
TIME
11:22:21
DATE
FRI
set correct time and date, Press
Set Daylight Saving Time
ILC LIGHTLEEDER
EDIT
Press
eDIT, scroll down until ClOCK appears
RELAYS
INPUTS
TIMERS
CLOCK
Press
TIME/DATE
DAYLIGHT SAVINGS
ASTRO CLOCK
SUNRISE/SUNSET
Press
DAYlIghT sAVIngs
CONFIG DST: ENABLED
START DATE
END DATE
set dates, Press
TUE
01/21/11.
09:46:54
PM.
NODE
01.
ClOCK
TIMe/DATe
AM
01/07/11
seT
TUE
01/21/11.
09:46:54
PM.
NODE
01.
ClOCK
CURRENT: STD
hOMe
Need help?
Do you have a question about the LightLEEDer and is the answer not in the manual?