Status; Behavior Of The Ri - Quectel BG96-NA Hardware Design

3.14. STATUS

The STATUS pin is an open drain output for indicating the module's operation status. It can be connected
to a GPIO of DTE with a pulled up resistor, or an LED indication circuit as below. When the module is
turned on normally, the STATUS will present a low state. Otherwise, the STATUS will present
high-impedance state.
Table 17: Pin Definition of STATUS
Pin Name Pin No.
STATUS 20
The following figure shows different circuit designs of STATUS, and you can choose either one according
to your application demands.

3.15. Behavior of the RI

AT+QCFG="risignaltype","physical" command can be used to configure RI behavior.
No matter on which port URC is presented, URC will trigger the behavior of RI pin.
NOTE
URC can be output from UART port, USB AT port and USB modem port by AT+QURCCFGcommand.
The default port is USB AT port.
BG96-NA_Hardware_Design
I/O Description
OD Indicate the module's operation status
Figure 21: Reference Circuit of the STATUS
Confidential / Released 41 / 64
LTE Module Series
BG96-NA Hardware Design
Comment
1.8V power domain