Ricoh D143 Field Service Manual page 1116

3. SP Mode Tables
007 Without Developer
008 With Developer
009 Serial Number 1
010 Serial Number 2
011 Adjustment: Vt
012 Adjustment: Vtref
013 Adjustment: Vtcnt
014 Adjustment: Gamma
015 Adjustment: Vcnt Result
[Waste Toner Full Detection]
3800
Displays/ adjusts the toner collection bottle detection settings. These SPs are used for
NRS.
001 Condition
002 Detection Times
003 Print Page After Near Full
004 Pixel Count After Near Full
Pixel Count After
005
Replacement
008 Coefficient
Notice Setting
011
NOTE:
If the toner collection bottle has been replaced before the machine detects used toner
near full when this setting is set to "0", the machine cannot detect toner collection bottle
near full. In that case, set SP3-902-017 to "1".
192
*ENG [0 to 5 / - / 0.1 V/step]
*ENG [0 to 5 / - / 0.1 V/step]
*ENG
[0 to 255 / - / 1 V/step]
*ENG
*ENG [0 to 5 / - / 0.1 V/step]
*ENG [0 to 5 / - / 0.1 V/step]
*ENG [0 to 5 / - / 0.01 V/step]
*ENG [0 to 2.55 / - / 0.01 mg/cm
*ENG [0 to 9 / - / 1 /step]
*CTL [0 to 4 / 0 / 1 /step]
*CTL [0 to 50 / 0 / 1 /step]
*CTL [0 to 1000 / 0 / 1 sheet/step]
*CTL [0 to 200000 / 0 / 1 cm
Displays the pixel counter after replacement
of toner collection bottle.
*CTL
[0 to 200000 / 0 / 1 cm
*ENG [0.1 to 1.5 / 1 / 0.1 /step]
Enables or disables the calling for @Remote.
[0 or 1 / 1 / - ]
*ENG
0: Enable @Remote calling
1: Disable @Remote calling
2
/kV /step]
2
/step]
2
/step]