Ricoh D143 Field Service Manual page 1144

3. SP Mode Tables
[Counter Up Timing]
5121
This program specifies when the counter goes up. The settings refer to "paper feed" and
"paper exit" respectively.
001 0:Feed 1:Exit
[F Size Original Setting]
5126
Selects F size original setting.
001 -
[APS Mode]
5127
This program disables the APS.
001 -
[Paper Size Type Selection]
5131
The program selects a paper size system from the following alternatives: the AB system
(0), the LT system (1), and the AF system (2).
001 -
5148 Size Detection Off
0: Detect
1: Not Detect
[Bypass Length Setting]
Determines whether the transfer sheet from the by-pass tray is used or not.
5150
Normally the paper length for sub scanning paper from the by-pass tray is limited to 600
mm, but this can be extended with this SP to 1260 mm.
001 0: OFF 1: ON
220
*CTL [0: Feed/ 1: Exit]
[0 to 2 / 0 / 1 /step]
0: 8 1/2" x 13" (Foolscap)
*ENG
1: 8 1/4" x 13" (Folio)
2: 8" x 13" (F)
*CTL [0: Not disabled/ 1: Disabled]
*ENG [0: JP (Japan)/ 1: NA / 2: EU]
*CTL [0: OFF/ 1: ON]
*CTL [0: OFF/ 1: ON]