INSPECTION OF WATER PUMP DRIVE
General
N N O O T T E E
If the edges of the idle gear teeth (1) or the water pump pinion (2) show signs of
wear, both gears must be replaced.
Instructions
See
1. Inspect water pump gear (1), idle gear (2) and water pump pinion (3) for cracks (visual
inspection).
2. Inspect the teeth of the idle gear (2) and the water pump pinion (3) for wear.
3. Inspect the hole and the two axial surfaces of the idle gear (2) for signs of wear.
Figure 5.21: Water pump drive
______________________________________________________
Chapter 5
Page 26
BRP-Rotax
REPAIR MANUAL
CRANK CASE INSPECTION
Figure: Water pump
drive.
Water pump gear 19 T
1
Water pump pinion 16 T
3
Idle gear 28/13 T
2
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0