N N O O T T E E
Take an available con rod pin (6) and push the old con rod (7) with needle bearing
and thrust washer onto the con rod pin. Note the installation instructions.
4. Take the gearbox-end of the crankshaft half (8) and repeat the procedure.
Figure 5.14: TYPICAL – Disassembling of the crankshaft
______________________________________________________
Chapter 5
Page 18
BRP-Rotax
REPAIR MANUAL
Thrust ring
1
3
Crankshaft half
Thrust pin
5
7
Con rod
9
Press
Thrust plate
2
Bottom section of the crankshaft repair jig
4
Con rod pin
6
8
Drive side of the crankshaft half
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0