Rotax 125 MAX evo Repair Manual page 79

Figure 5.9: Bearing and oil seal for shaft
______________________________________________________
Clutch end case half
Instruction See
7. Remove case half (1) from the convention oven and drop onto a flat wood board. This re-
leases the ball bearing (2) of the crankshaft and the ball bearing (3) from the case.
8. Invert the case half and remove the needle bushing (5) with the installation tool (4).
Chapter 5
Page 12
REPAIR MANUAL
1 Oil seal AS 28x38x7
3 Oil seal A 10x26x7
5 Allen screw M6x20
7 Countersunk screw M5x12
Wear heat-resistant gloves during this process!
Figure: Clutch end case
BRP-Rotax
2
4
6
8
m WARNING
Danger of severe burns and scalds!
half.
Oil seal AS 25x38x7
Pick up sensor
Air vent screw M18x1.5
Thrust washer
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0