Assembling Of Electric Starter - Rotax 125 MAX evo Repair Manual

1. Secure the rotor shaft with a suitable tool.
2. Pull out solenoid housing.
3. Pull the rotor shaft from the starter motor support.
4. Unscrew the bracket for the positive contact.
5. Press out the rubber grommet.
6. Extract the positive contact by pulling it inwards through the plastic ring.
N N O O T T E E
If necessary, unscrew the rubber seal and the ground pole from the starter sup-
port and clean them.
Figure 7.16: Electric starter disassembly

ASSEMBLING OF ELECTRIC STARTER

Instructions
N N O O T T E E
The brushes must contact the slip ring correctly.
1. Inspect the carbon brushes and replace if necessary with new parts (ROTAX® part no.
281262).
2. Insert the plastic ring in the starter motor support so that it does not rotate.
3. Insert the positive contact from inside through the plastic ring and the cutout in the starter
motor support.
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
BRP-Rotax
REPAIR MANUAL
Chapter 7
Page 15