Figure 5.8: Crankcase
______________________________________________________
REMOVING BEARING AND OIL SEAL FOR SHAFT
Special tools
The following special tools and equipment are required:
Instructions
See
1. Remove oil seal (1) and (2) from the two halves with suitable tools.
2. Remove oil seals (3) from water pump with suitable tools.
3. Remove pick up sensor (4) for the ignition system by removing the two Allen screws (5).
4. Remove air vent screw (6).
5. Remove countersunk screw (7) and thrust washer (8).
6. Heat the two halves of the case to approx. 150 °C in the convection oven until the bearing
can be tapped gently out.
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
BRP-Rotax
REPAIR MANUAL
1
Crankshaft
3
Plastic hammer
Part no.
n.a.
676030
Figure: Bearing and oil seal for
2
Crankcase half
Description
Convection oven
Installation tool
shaft.
Use
Case halves
Needle bearing
Chapter 5
Page 11