Installation Of The Clutch Drum - Rotax 125 MAX evo Repair Manual

Figure 7.21: Installation of bearing sleeve
______________________________________________________

INSTALLATION OF THE CLUTCH DRUM

Safety
Special tools The following special tools and equipment are required:
Instruction
1. Lubricate crankshaft with lithium based grease in the running area of the needle cage (4).
2. Position thrust washer 15.2 (6) and O-ring (5) on the crankshaft.
3. Lubricate the needle cage (4) with lithium based grease and position on crankshaft.
4. Slide clutch drum (3) onto the crankshaft.
5. Lubricate the crankshaft with LOCTITE 243 in the thread area of the hex. nut.
6. Tighten hex. nut (1) with thrust washer (2) (machined side towards the clutch drum). Tighten-
ing torque 35 Nm (26 ft.lb).
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
BRP-Rotax
REPAIR MANUAL
Bearing sleeve
1
3 Clutch drum
The engine must not be started without a clutch drum.
Part no.
897651
897330
Beveled edge
2
m WARNING
Risk of fatal injury!
Description
LOCTITE 243
Lithium-based grease
Field of application
Crankshaft thread
Running areas
Chapter 7
Page 21