Carburetor And Intake Silencer View - Rotax 125 MAX evo Repair Manual

Instruction To install the carburetor and intake silencer the following steps are required:
See
1. Pull the hose clamp (3) over the carburetor flange.
2. Push the carburetor (1) onto the carburetor flange (2) and fasten the hose clamp (3).
3. Secure the intake silencer (4) with the hose clamp (5) on the carburetor.
4. Secure the intake silencer on the support bracket (6).
5. Check the Bowden cable (11) for wear, especially where it bends. Bends can cause the throt-
tle to be stuck in fully open. See Chapter 9.
6. Connect the fuel feed line (9) and Bowden cable (11) to the carburetor.
7. Connect the impulse pipe (10).
Figure 6.11: Carburetor and intake silencer
______________________________________________________
Chapter 6
Page 14
REPAIR MANUAL
Figure: Carburetor and intake
1 Carburetor
Hose clamp
3
Hose clamp 51
5
7 Allen screw M6x25
9 Fuel feed tube/line
Bowden cable (loosely, not mounted in
11
fig.)
BRP-Rotax
silencer.
2
4
6
8
10
Carburetor flange
Intake silencer
Support bracket
Washer 6.4
Impulse pipe
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0