Safety note
Ignition "OFF"
This precautionary measure serves to avoid any injuries in case of an unintentional start
"OFF" and system grounded, 2) Disconnect battery and secure engine against uninten-
Handling of fluids
At maintenance of cooling-, lubricating and fuel system take care without that no contami-
nation, metal chips, foreign material and/or dirt enters the system.
Disassembly
At disassembly of the engine, mark the components as necessary to avoid any mix-up.
Take care of these marks, do not ruin them.
Tool
In order to avoid mechanical damages, never loosen or tighten screws and nuts with pli-
Safety wiring
Chapter 2
Page 4
REPAIR MANUAL
PROCESS ADVICE
Non-compliance can result in serious injuries or death!
When carrying out maintenance and service work, respect without fail the safety
Non-compliance can result in serious injuries or death!
of the engine. Principally ensure the following at each maintenance event:1.) Ignition
Non-compliance can result in serious injuries or death!
Non-compliance with this instruction may cause severe burns or scalding! Hot engine
parts! Always allow the engine to cool down to ambient temperature before starting
If during diassembling/reassembling the removal of a safety item (e.g. safety wiring,
self-locking fastener, etc.) should be necessary, it must be always replaced by a new
BRP-Rotax
m WARNING
regulations.
m WARNING
tional operation.
m WARNING
work.
ATTENTION
ers but only with the specified tools.
ATTENTION
one.
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0