INSPECTION OF THE FUEL PUMP
General
N N O O T T E E
Only the complete membrane and gasket set of the fuel pump can be replaced.
Fuel pump gasket set: Part no. 296165
Instruction
See
1. Check the condition of the impulse pipe (1), fuel line (2) and fuel overflow line (3) and in case
of doubt replace them.
Figure 6.7: Fuel pump
______________________________________________________
INSPECTION OF THE INTAKE SILENCER
General
A damaged filter element must be replaced immediately. Otherwise dirt particles
Instruction
See
1. Inspect the silencer case (1) and silencer cover (2) for cracks.
2. Inspect the intake silencer tube (3) and carburetor socket (10) for cracks or porosity.
3. Clean the filter element (5) with filter cleaner and oil it afterwards slightly with air filter oil.
4. Inspect the filter element (5) and filter element holders (4) for cracks.
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
BRP-Rotax
REPAIR MANUAL
Figure: Fuel
pump.
Impulse pipe
1
Fuel line (to carburetor)
3
can enter the intake and cause damage to the engine.
Figure: Intake
silencer.
Fuel line (from fuel tank)
2
ATTENTION
Chapter 6
Page 9