Figure 5.10: Clutch end case half
______________________________________________________
Ignition end case half
N N O O T T E E
The wooden board must have cutouts for the two dowels (1) and the locating pin
(2) to form a flat base for the case half.
If it is necessary to replace the locating pin (2), it can be removed from the hot
case with a pipe wrench.
Instruction
See
9. Remove case half (3) from the convection oven and drop onto a flat wood board with the
case split pane. This removes the ball bearing (4,5) from the crankshaft and the balance
shaft.
10. Allow both crankcase halves to cool to room temperature (20 °C) (274 °F).
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
REPAIR MANUAL
Crank case assy.
1
Ball bearing 6302
3
Needle bushing 8x12x8
5
Figure: Ignition side
crankcase.
BRP-Rotax
2
4
6
Ball bearing 6206
Installation tool part no. 676030
Tube
Chapter 5
Page 13