Configuring Catch Monitoring Sensors; Configuring A Px Multisensor Mk2 For A Sr Type Receiver Unit - Simrad TV80 Reference Manual

Simrad TV80 Reference Manual

Configuring catch monitoring sensors

Topics
Configuring a PX MultiSensor mk2 for a SR type receiver unit, page 110
Configuring a PX MultiSensor mk2 for a PI type receiver unit, page 112
Configuring a PX Universal and a PX MultiCatch sensor for a SR type receiver unit, page 114
Configuring a PX Universal and a PX MultiCatch sensor for a PI type receiver unit, page 116
Configuring a PX TrawlEye sensor, page 118
Configuring and setting up the PX MultiSensor mk2, PX Universal and PX Multicatch for
different measurements, page 119
Adding more measurements to a PX MultiSensor mk2, page 121
Modifying the parameters of a sensor, page 122

Configuring a PX MultiSensor mk2 for a SR type receiver unit

Catch monitoring sensors are delivered from Kongsberg Maritime AS readily set up with
common default settings. When required, each individual sensor may be configured to
specify its communication channel and which measurements to make.
Prerequisites
This procedure assumes that a suitable receiver unit has been connected to the Processor
Unit, and that all relevant communication parameters have been defined.
Context
The dialog boxes allow you to set up which measurements the
PX MultiSensor Configurator
sensor shall make, the communication channel and some other relevant parameters.
Depending on your hardware configuration and the type of sensor, you may configure two
measurements or up to five.
Note
The TV80only allows you to configure PX sensors. If you wish to use older sensors (not PX
family), these must be configured using their dedicated applications before you add them.
110
406388/B