Advanced Dialog Box - Simrad TV80 Reference Manual

Simrad TV80 Reference Manual
The
PX MultiSensor Configurator
connected.
You need a special interface unit or cable to do the configuration task yourself.
How to open
The
PX MultiSensor Configurator
box. The
PX TrawlEye Configurator
open the
Add New Sensor
page. The
Sensor List
box is located on the
Description
If you do not calibrate your sensors you will not know if the pitch and roll readings are
correct. If existing sensors have been replaced, or new sensors have been installed, a new
calibration is always required. A new calibration may also be required after an update of
the TV80 software.

Advanced dialog box

Once defined the measurements you want your catch monitoring sensor to make, you can
optimise their range values in order to get a better resolution.
How to open
The dialog box, is opened from the
Advanced
dialog box is opened from the
PX Configurator
dialog box, select
New Sensor
page is located in the
Sensor List
located on the
Setup
Description
The dialog box shows the measurements or functions defined in the corresponding
Advanced
dialog box. You can define a minimum and a maximum value for every
PX Configurator
measurement.
If the catch monitoring sensor measures a value outside the range you defined, it will not
be sent to the vessel.
242
dialog box is only available if there is a PX MultiSensor
dialog box is opened from the
is opened from the
dialog box, select
page is located in the
menu.
Setup
Add New Sensor
Installation
menu.
Add New Sensor
at the bottom of the
Add New Sensor
dialog box. The
Installation
PX MultiSensor Configurator
dialog box. To open the
Add New Sensor
at the bottom of the
dialog box. The
Installation
dialog
Add New Sensor
dialog box. To
Sensor list
dialog
Installation
dialog box. The
page. The
Sensor list
dialog box is
406388/B
Add