Receiver Settings; Adjusting The Receiver Sensitivity For The Pi50 And Pi60 Receiver Units - Simrad TV80 Reference Manual

Simrad TV80 Reference Manual

Receiver settings

Topics
Adjusting the receiver sensitivity for the PI50 and PI60 Receiver Units, page 124
Reducing noise disturbance from the data received on a SR15 or SR70 Receiver Unit,
page 125
Adjusting the receiver sensitivity for the PI50 and PI60
Receiver Units
The parameter used to adjust the receiver sensitivity is the
parameter is used to control the threshold level for detection of signals. The
box allows you to set up the detailed parameters for the signal reception.
Prerequisites
The dialog box is only available when you have set up a serial line communication
Receiver
with a sensor receiver.
Context
Each receiver must be able to accept and recognize the data from the catch monitoring
sensors. However, sea conditions will vary, and the acoustic conditions are also changing.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
3 Observe the
I/O Setup
Every interface is presented as a small "block diagram".
124
menu.
Installation
dialog box opens.
Installation
page on the right side of the
Detection Threshold (DT).
.
Installation
This
dialog
Receiver
dialog box.
406388/B