Setting Up The Tv80 Catch Monitoring Software For The First Time; Setting Up Summary - Simrad TV80 Reference Manual

Getting started
Setting up the TV80 Catch monitoring software
for the first time
Topics
Setting up summary, page 51
Defining the IP address on the Processor Unit network adapter, page 52
Installing the TV80 operational software, page 54
Starting the TV80 program, page 55
Obtaining and installing the software license, page 56
Setting up the SR15 Receiver Unit on an Ethernet (LAN) port, page 57
Setting up the SR70 Receiver Unit on an Ethernet (LAN) port, page 58
Setting up the PI50 and PI60 Receiver Units on a serial line input, page 40
Defining the serial line communication parameters for the PI50 and PI60 Receiver Units,
page 61
Selecting gear, page 62
Adding a new sensor, page 63
Creating a new sensor view, page 65
Creating a TrawlEye view, page 67
Inspecting the receiver quality, page 69

Setting up summary

Before a new TV80 system can provide any information you must set it up. You must first
install the software. In order to add one or more catch monitoring sensors to your system, you
must first connect the necessary receiver unit(s), and define the communication parameters.
Finally, you must set up the communication parameters for your navigation sensors.
Prerequisites
• All system units have been installed.
• All cables have been connected and verified.
• All system units have been inspected.
• The TV80 operational software is available.
51
406388/B