Table of Contents
Advertisement
3
At the bottom of the
The
Add New Sensor
4
Select
.
Yes
5
In the
PX Sensor Configurator
then select
Connect
The
PX TrawlEye Configurator
6
Select the location of the sensor on the gear.
7
Define the sensor parameters.
See
Overview of sensors channels and frequencies, page
configuration parameters, page 264 Specific configuration parameters for PX TrawlEye
sensors, page 267
8
Select
Program Sensor
Result
The new sensor appears on the
The
page presents a table with all the catch monitoring sensors that have been
Sensor List
added to the system. You can see if they are currently in use or disabled. You can also
see relevant information about the sensors, such as type, receiver in use, communication
channel, and where they are placed on the fishing gear.
Related topics
PX TrawlEye Configurator dialog box, page 229
PX MultiSensor mk2 Configurator dialog box, page 236
Main PX Sensors configuration parameters, page 264
Specific configuration parameters for PX TrawlEye sensors, page 267
Overview of sensors channels and frequencies, page 269
Configuring and setting up the PX MultiSensor mk2, PX
Universal and PX Multicatch for different measurements
Catch monitoring sensors are delivered from Kongsberg Maritime AS readily set up with
common default settings. When required, each individual sensor may be configured to
specify its communication channel and which measurements to make.
Prerequisites
This procedure assumes that a suitable receiver unit has been connected to the Processor
Unit, and that all relevant communication parameters have been defined.
406388/B
page, select
Sensor list
dialog box opens.
dialog box, select communication port and sensor type,
.
dialog box opens.
to transfer the chosen parameters to the sensor.
page.
Sensor List
.
Add New Sensor
269,
Main PX Sensors
Operating procedures
119
Advertisement
Table of Contents
