Table of Contents
Advertisement
Simrad TV80 Reference Manual
2
On the
menu, select
Setup
Observe that the
3
Observe the
I/O Setup
4
Select
Add LAN Port
Observe that the
5
Select the SR15 Receiver Unit.
Every new interface is presented as a small "block diagram" on the
Result
Every interface is presented as a small "block diagram". The
number of "inspection points". These are small circular icons with an "i".
Inspection points provide important information about the connection. By selecting an
inspection point you can retrieve relevant information about the connection. The colour of
an inspection point helps you to identify the quality of the information that is received.
• When an inspection point is green, the information is properly received.
• When an inspection point is red, it means that a specific datagram is not recognized. This
is not a critical error since many systems have proprietary NMEA datagram sentences
that are not used, and therefore do not need decoding.
Setting up the SR70 Receiver Unit on an Ethernet (LAN) port
The SR70 Receiver Unit allows you to receive information from: PX MultiSensor mk2,
PX MultiCatch and PX TrawlEye sensors. The Receiver Unit must be connected to the
Processor Unit using an Ethernet line.
Prerequisites
In order to connect a catch sensor to the TV80 system, the following requirements must be
met.
• The TV80 software is installed on the Processor Unit.
• The license string for the software is installed and activated.
• One or more receivers are available for connection to the TV80.
58
Installation
dialog box opens.
Installation
page on the right side of the
.
dialog box opens.
Select Input (LAN)
.
Installation
I/O Setup
dialog box.
page.
I/O Setup
page also presents a
406388/B
Advertisement
Table of Contents
