Table of Contents
Advertisement
Simrad TV80 Reference Manual
• The TV80 software license is available.
Procedure
1
Do the following preparations.
a
Turn on the Processor Unit.
b
Verify that you have administrative rights.
c
Switch off any firewall applications.
d
Open the operating systems's Network and Sharing Center, and set the IP address
for the network adapter used to communicate with the transceiver.
•
IP Address
•
Subnet mask
2
Install the TV80 operational software.
3
On the
Software License
4
Connect the Receiver Unit to the Processor Unit.
5
Set up the SR70 Receiver Unit / SR15 Receiver Unit in the TV80 application.
6
Set up the PI50/PI60 Receiver Unit in the TV80 application.
7
Select the gear you wish to use.
8
Select one or more catch monitoring sensors, and place them on the chosen gear.
9
Open the
Receiver
filter and gain.
10 Open the
Measurements
information.
Defining the IP address on the Processor Unit network adapter
The communication between the Processor Unit and the SR70 and SR15 Receiver Units
is made using a high speed Ethernet cable. You must define which IP Address and Subnet
mask the Ethernet adapter in the Processor Unit shall use for this communication. As long
as you do not change the Processor Unit to another computer, or replace the network adapter
in your Processor Unit, you will only need to do this once.
Context
You will only need to set up the IP address on the Ethernet adapter if you are going to
communicate with an SR70 or SR15 Receiver Unit.
52
: 192.168.1.30
: 255.255.255.0
page, install the software license(s).
dialog box to define the parameters related to reception, such as
dialog box to verify that each sensor provides the expected
406388/B
Advertisement
Table of Contents
