Table of Contents
Advertisement
Simrad TV80 Reference Manual
Setting up the SR15 Receiver Unit on an Ethernet (LAN) port
The SR15 Receiver Unit allows you to receive information from the PX catch monitoring
sensors: PX MultiSensor mk2, PX MultiCatch and PX TrawlEye. The Receiver Unit must
be connected to the Processor Unit using an Ethernet line.
Prerequisites
In order to connect a catch sensor to the TV80 system, the following requirements must be
met.
• The TV80 software is installed on the Processor Unit.
• The license string for the software is installed and activated.
• One or more receivers are available for connection to the TV80.
Context
The SR15 Receiver Unit comprises a rugged box providing all necessary receiver electronics.
The receiver is designed for low noise, and it can handle input signals spanning a very large
instantaneous dynamic amplitude range. All targets are correctly measured and displayed.
The SR15 Receiver Unit allows you to connect one single hydrophone. Depending on
your fishing requirements, you may need to install more than one hydrophone to receive
the information from the catch sensors. With a single channel receiver, you must manually
switch between the hydrophones to check which hydrophone that provides the best
communication.
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
3
Observe the
I/O Setup
4
Select
Add LAN Port
Observe that the
5
Select the SR15 Receiver Unit.
Every new interface is presented as a small "block diagram" on the
Result
Every interface is presented as a small "block diagram". The
number of "inspection points". These are small circular icons with an "i".
38
menu.
Installation
dialog box opens.
Installation
page on the right side of the
.
dialog box opens.
Select Input (LAN)
.
Installation
I/O Setup
dialog box.
page.
I/O Setup
page also presents a
406388/B
Advertisement
Table of Contents
