Table of Contents
Advertisement
Temporarily removing a sensor from the presentation
The
page presents a table with all the catch monitoring sensors that have been
Sensor List
added to the system. In the
it from the current presentation.
Prerequisites
The relevant catch monitoring sensors were attached to the fishing gear before it was
deployed.
You have selected the type of gear you wish to use. The serial and/or Ethernet ports have
been defined and configured in order to allow for communication with external hardware.
Context
Different catch monitoring sensor types may be used with the TV80. Depending on the type
of fisheries or on the current fishing scenario, you may not need to use all the sensors you
have previously configured. With
that sensor presented on your current presentation.
Procedure
1
On the
menu, select
Setup
Observe that the
2
In the
Sensor list
presentation.
3
Observe the
On Gear
A check mark in
When there is no check mark in
4
Select
On Gear
Result
Your presentation will not show the information from the sensors that do not have a check
mark on the
On Gear
Related topics
Sensor List page, page 208
406388/B
page you can choose a sensor and temporarily disable
Sensor List
On Gear
Installation
dialog box opens.
Installation
page, observe the sensor you want to temporarily remove from your
check box at the right of the list.
indicates that the data from that sensor is being presented.
On Gear
On Gear
to disable the check mark.
check box.
you can decide if you want to have the data from
.
, no data from the sensor is being presented.
Operating procedures
109
Advertisement
Table of Contents
