Table of Contents
Advertisement
Simrad TV80 Reference Manual
4
In the relevant block diagram, select the serial port icon.
Observe that the
5
Make the necessary adjustments.
The communication parameters defined for
•
: 4800 b/s
Baud rate
•
: 8
Data bits
•
: None
Parity
•
: 1
Stop bits
Some instruments may offer other parameters and/or choices. You must always check
the relevant documentation provided by the manufacturer.
6
Select
to save the chosen settings and close the dialog box.
OK
Defining receiver parameters for the PI50 and PI60 Receiver
Units
The
dialog box allows you to set up the detailed parameters for the signal reception.
Receiver
It allows you to "fine tune" the receiver for optimal performance. Sea conditions will vary,
and the acoustic conditions are also changing.
Prerequisites
This procedure assumes that a receiver has been connected to the Processor Unit by means
of a serial line, and that the communication line has been initiated.
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
3
Observe the
I/O Setup
Every interface is presented as a small "block diagram".
42
dialog box opens.
Serial Port Setup
menu.
Installation
dialog box opens.
Installation
page on the right side of the
are:
NMEA 0183
.
Installation
dialog box.
406388/B
Advertisement
Table of Contents
