Table of Contents
Advertisement
Turning the TV80 on and off
Topics
Starting the TV80 program, page 29
Turning off the TV80, page 30
Starting the TV80 program
The TV80 is a software program, and you start it just like any other computer programs.
You must power up the display, the Processor Unit, and the sensor receiver(s).
Prerequisites
This procedure assumes that you have connected one or more sensor receivers to the
Processor Unit.
Context
The program is not automatically started when the Processor Unit is turned on. Double-click
the TV80 icon on the Processor Unit desktop to start the program.
Procedure
1
Turn on the display.
If required, refer to the instructions provided by the display manufacturer.
2
Turn on the Processor Unit.
Wait for the operating system to start up.
3
On the Processor Unit desktop, double-click the TV80 icon to start the program.
4
Select user settings.
During the program load, a dialog box appears to let you choose from the current user
settings available on the TV80. The dialog box is only visible a few seconds. You do
not need to make a choice here. You can select your predefined user setting at any time
by means of the
5
Once the TV80 program has started, observe that the presentation fills the entire screen.
The program starts up using the same settings as the last time you used it. If these
settings are acceptable, continue operation. If you wish to alter any of the settings, see
the relevant procedures.
406388/B
dialog box on the
User Settings
menu.
Main
Getting started
29
Advertisement
Table of Contents
