Cover Removal - Omron Pioneer LX User Manual

Table of Contents
CAUTION: Pinch hazard. The magnets holding the covers in place are strong enough
to pinch you if you are not careful.
NOTE: In general, it is better to install the payload first, and then the covers.
The covers are:

Rear Inner (Battery)

Access Panel

Left Side
Both side covers include a light disc and cover.

Right Side

Front Upper

Bumper

Rear Outer
With the exception of the bumper cover, no tools are needed for either the removal or installation of the
covers.

Cover Removal

NOTE: After removing covers, place them inner-side down, so the outer surfaces don't get
scratched.
The covers can be removed in the order in which they are listed above.

The rear outer must wait for the rear inner and the two side covers.

The front upper must wait for the two side covers.

The two sides, the rear inner, and the bumper cover can all be removed without removing any
other covers, except that the left cover must wait for the access panel.
NOTE: The light disc covers are not covered here because they are only removed from the side
covers to replace one of the light disc controllers.
Rear Inner Cover (Battery)
This provides access to the battery compartment door.
1. Pull the bottom of the cover away from the platform chassis.
This is easiest if you grip it with two hands, toward the center.
2. Lower the cover down, so its top tab clears the rear outer cover.
Joystick and External Ethernet Port Access Panel
This provides access to the Maintenance Ethernet and the Joystick ports.
Page 94 of 134